Using Ninja Ripper with Dolphin
|
Using Ninja Ripper with Dolphin
|
|
07-08-2014, 07:27 PM
tried DXRipper out on 32-bit DX9 dolphin. It will give a dump, but nothing I could comprehend when loaded into Milkshape. tried the different XYZ combinations, but most the meshes were stretched out at extremes. I think only one object retained its shape, and it wasn't the one i wanted.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Using Ninja Ripper with Dolphin - by Viremaster - 07-08-2014, 09:55 AM
RE: Using Ninja Ripper with Dolphin - by Mystie - 07-08-2014, 10:02 AM
RE: Using Ninja Ripper with Dolphin - by Viremaster - 07-08-2014, 07:27 PM
RE: Using Ninja Ripper with Dolphin - by Mystie - 07-10-2014, 09:32 PM
RE: Using Ninja Ripper with Dolphin - by Viremaster - 07-11-2014, 12:25 PM
|
